跳到内容
Localtonet Localtonet 控制台

此页面暂无简体中文版本,当前显示英文。

Configure a Network and IP Address

If you have more than one IP on your device and want these IPs to be selected from different tunnels or localtonet applications, here is how to do this.

指南 阅读约 1 分钟 更新于 2026年8月28日星期五 阅读完整博客文章

获取本页帮助
本页内容 1 个章节
  1. Save the arguments
  2. For Localtonet
  3. For one tunnel

Run Localtonet on a specified network and IP address globally or for an individual tunnel.

Prerequisite: Localtonet v6.6 or later.

  1. List detected networks and identify those with internet access:

    localtonet --network
  2. Start Localtonet with the required network and IP address:

    localtonet --net [networkname] --ip [ipaddress]

    Replace [networkname] with the network name and [ipaddress] with the IP address.

Save the arguments #

For Localtonet #

  1. Open the My Token page.

  2. Under Settings, enter --net [networkname] --ip [ipaddress] in the Arguments field.

  3. Save the settings.

For one tunnel #

  1. Open Tunnel Settings for the required tunnel.

  2. Enter --net [networkname] --ip [ipaddress] in the Arguments field.

  3. Save the configuration. These settings apply only to the selected tunnel.

支持