Skip to content
Localtonet Localtonet Dashboard

Configure a Network and IP Address

If you have more than one IP on your device and want these IPs to be selected from different tunnels or localtonet applications, here is how to do this.

Guide 1 min read Updated August 28, 2026 Read the full blog post

Get help with this page
On this page 1 section
  1. Save the arguments
  2. For Localtonet
  3. For one tunnel

Run Localtonet on a specified network and IP address globally or for an individual tunnel.

Prerequisite: Localtonet v6.6 or later.

  1. List detected networks and identify those with internet access:

    localtonet --network
  2. Start Localtonet with the required network and IP address:

    localtonet --net [networkname] --ip [ipaddress]

    Replace [networkname] with the network name and [ipaddress] with the IP address.

Save the arguments #

For Localtonet #

  1. Open the My Token page.

  2. Under Settings, enter --net [networkname] --ip [ipaddress] in the Arguments field.

  3. Save the settings.

For one tunnel #

  1. Open Tunnel Settings for the required tunnel.

  2. Enter --net [networkname] --ip [ipaddress] in the Arguments field.

  3. Save the configuration. These settings apply only to the selected tunnel.

Support